Multi Compartment Boxes in Dubai

A rigid box whose interior is divided into separate cavities, one per item or per group of items, using cut board dividers, a moulded pulp sheet or a foam tray. The dividers hold each product in its own space so nothing moves, leans into a neighbour or carries scent and colour across the box. On a rigid build the dividers also brace one another, which is what keeps the grid square.

One cavity per distinct product, plus a spare only where you genuinely ship a smaller box with a pocket left empty. An unused cavity reads as an error through an open lid and wastes board on every unit. We count your products against the footprint and will tell you when an extra pocket is there for a reason rather than by accident.

Board dividers usually run between 1.2mm and 2.0mm, and the choice trades stiffness against usable width. A thicker wall stops the grid racking but takes width from the pockets on either side of it, so a 3mm divider across a 90mm span costs 6mm of product space. Light items suit 1.2mm to 1.5mm; heavier or fragile products justify going to 2.0mm.

Divider tops are set below the box rim by the lid clearance, typically 1.5mm to 2mm, so a lid pressing down cannot load the dividers and bow them. Flush divider tops are the most common fault we are asked to correct: the lid either binds on the corners of the grid or sits visibly proud down one side of the box.

Because the dividers are load-bearing. Each wall is holding a product in place and resisting sideways movement, and inside a rigid, corner-assembled outer the whole grid braces itself. Put the same dividers in a folding carton and they buckle, the pockets square off, and the layout you approved is not the layout that reaches the customer.

Each pocket is cut to a stated clearance above the product's real measurement rather than to a nominal size, and the cavities on a single tray are cut in one pass so they agree with each other. Where a product varies between production batches, we quote the tolerance and cut to the largest measurement rather than to an average.

A moulded pulp sheet gives a thinner, recyclable grid and works well for lighter products. Cut foam or EVA allows a far finer cavity, which is why it is used for watches and jewellery. A folded paperboard tray suits flat items and keeps the cost down when the contents are light and undamaged by handling.

Usually, and a box that gets kept is often the reason a brand spends on a rigid divided build instead of a carton. The grid is the part that fails first, so we can thicken the dividers, add a base pad and stiffen the corners to a specification for repeat filling rather than for a single opening.

Yes. Boxes reach every emirate, from Dubai and Sharjah out to Ras Al Khaimah and Fujairah, with the window agreed against your production date rather than a generic lead time. Kitted boxes can be delivered filled, already in your packing sequence.

Minimums depend on cavity count, divider caliper, board grade and finishing, because each additional cavity adds divider board and another set of edges to finish. We confirm the figure against your brief, and the number in your quote is the number for the layout you approved rather than a cheaper grid quietly substituted later.